Chemical Engineering GATE Exam
Jobs Salary Internship Colleges Careers Syllabus Notes
Posted by admin on January 12, 2010 under Heat Transfer | 
2 Comments to Read
if main steam header pressure is 160psi.Will Pressure regulation at inlet of heat exchanger help to descipate more heat?
Posted by admin on January 11, 2010 under Heat Transfer | 2 Comments to Read
actually i want to know how to define the power required for air cooled heat exchanger fan.
thanx!
Posted by admin on January 10, 2010 under Heat Transfer | 2 Comments to Read
It’s a Marthon 27′ cabin cruiser with a Chevy/OMC 350 stern drive. I would like to convert it and was wondering what the cheapest and best way to do this is. I want to take it in salt water for extended periods and I don’t want to ruin the motor. I’ve been researching heat exchangers but it’s kind of confusing. Any advise appreciated, thanks.
Posted by admin on January 9, 2010 under Heat Transfer | 2 Comments to Read
want to know downtime cost estimate, mean time to repair, logistics support, and any other information relating to heat exchanger maintenance
Posted by admin on January 8, 2010 under Heat Transfer | Read the First Comment
Other diagrams I’ve seen either show a ‘flue collector’ that the flue rests on, holding it several inches above teh heat exchanger, of include a tab on the flue that I assume might keep the bottom of the flue opening several inches above the exchanger? This is a laars lite 175 model. I’ve just had to replace the exchanger and wonder if this may be part of the reason that it began leaking after only 6 years.
Posted by admin on January 6, 2010 under Heat Transfer | 4 Comments to Read
is the heating &domestic water mixing ?caused by an old heat exchanger ?
Posted by admin on January 5, 2010 under Heat Transfer | Read the First Comment
I plan to design the microchannel heat exchanger for seawater desalination plant, by using naval brass and titanium as its materials.
Posted by admin on January 4, 2010 under Heat Transfer | 3 Comments to Read
i’m doing this experiment on heat exchanger. I’m supposed to discuss the effect of changing the flow rate on the overall heat transfer coefficient as well as the effect on the temperature and efficiency. I need some help so anything would be great.
Posted by admin on January 3, 2010 under Heat Transfer | 2 Comments to Read
Our house has heat recovery ventilation. The time regulated controls never worked, so it is always set to min. But the shower room gets very condensated, and we have to manualy up the ventilation speed. The shower is operated from a heat exchanger off the boiler, and activated by a flow sensor (mains electric) Any ideas on how to set the ventilation unit to high speed when showering???
Posted by admin on January 2, 2010 under Heat Transfer | 2 Comments to Read
Heat exchanger is cracked. Still under warranty accept for install costs.
Powered by Yahoo! Answers
